Replacement Lens Set — Front / Rear
Before you begin: turn off the vehicle and remove the key. Disconnect the negative (–) battery terminal to avoid electrical shorts. Make sure the surface is clean and dry before reassembly.
Tools you’ll need
- T-15 Torx screwdriver
- Plastic trim removal tool or flathead screwdriver
Included
- Replacement lens(es)
- Access the marker light
- Remove the screws from the front of the marker light housing using a T-15 Torx screwdriver.
- Remove the old lens
- Remove the LED marker light from the car.
- Unplug the LED marker light from the car wiring.
- Pull the LED backing plate out of the housing trim to release the lens.
- Remove the lens from the housing trim.
- Inspect the LED unit
- Check that the LED board and wiring are undamaged and dry.
- Ensure no debris or moisture is inside the housing.
- Install the new lens
- Line up the new lens with the LED housing, making sure it is aligned properly.
- Secure the lens
- Reinsert the LED backing plate into the housing trim.
- Reinstall the LED housing back onto the car and tighten the screws.
- Final check
- Reconnect the battery and turn on your parking lights to confirm the LEDs are working.
Notes. Lenses are side-specific — install the correct front/rear or left/right unit. Handle the lens carefully to avoid scratching the surface. If the housing shows wear or cracking, consider replacing the full unit.