Pontiac Fiero Front Fascia Badge
Tools you may need
- Rubbing alcohol and microfiber cloth
- 2.5mm hex key
- Socket wrench, for factory badge removal
- Super glue
Included
- Replacement front fascia badge / mounting plate
- 2.5mm hex key
- M4×10 stainless bolt
- Access the back side
- Reach inside the air opening in the front of the aero nose to access the nut holding the badge.
- You may need to remove the front fascia panel or reach through openings behind the nose area.
- Use a socket wrench to unscrew the nuts securing the badge studs.
- Remove the old badge
- Once unbolted, gently push the badge outward from the back side and remove it.
- Clean any grime or residue from the surface with rubbing alcohol and a microfiber cloth before installing the new one.
- Install the new badge
- Insert the alignment pin into the matching hole in the bumper fascia.
- Add one drop of super glue before fully seating the alignment pin.
- Insert the badge’s studs into the existing holes and thread the M4×10 bolt from behind using the 2.5mm hex key.
- Tighten snugly — do not overtighten.
Pro tips. Clean and dry the mounting surface thoroughly for the best bond. If the alignment pin hole is tight, test fit before applying super glue. A second set of hands helps when reaching through the nose opening.
Notes. Replacement badges may vary slightly in size depending on manufacturer — always verify fitment. If your fascia has paint fading or damage around the old badge, consider touching it up before installing. For show-quality results, remove the front fascia to access the mounting points more easily.